Custom Built in the USA.
the
Model# S-TMP-TWOK-F provides on the fly Nav running/Strobe changing effect for both TMP and TWOK versions of the Enterprise NCC-1701 Refit using a single push button. This board also
controls the fantail light which is steady on in TMP and runs in sync with Nav running lights in TWOK.
If you are torn between which refit to build, here is your solution.
Also included is a 5mm red/blue LED you can connect to a 3 way toggle switch to change the color of the Impulse crystal to match your mode. Switch not included.
makes accurizing your model easy. Small enough to fit many scales of the Enterprise NCC-1701 Refit.
Make your hard work as Life like and detailed as possible.
Board contains circuit for Navigational Strobe and Navigational Running lights, as well as fantail light.
Designed for ease of use and longevity, the board can be mounted directly inside the model or stand.
Powered by 6volt to 12volt power supply either by battery or by a"Regulated" DC power
supply adapter that you plug in to the wall(Not Included).
Board Features:
Circuit may be used to strobe 10 single LEDs in parallel or 10 pair of LEDs in parallel wiring 2 LEDs in series for a total of 20 LEDs, depending on your power supply, on both LED Connections.(note: Enterprise NCC-1701-A Model requires only 4 Nav strobes and 10 Nav Running lights). Fantail supports a max of 1 LED.
Easy connection via a 2 pin header block. (JST connectors may be used or just solder to the posts.)
Approximate Dimensions: 1 1/2" x 1 1/4"
Other Uses
For those in need of running lights for your RC Planes, etc, this board can be programmed with many types of flash rates. Please contact me with any questions. Can be used in Model railroads, aircraft, boats, spacecraft, towers, bridges, etc. Limited only by your Imagination.
Video
Please view video below to see both effects. Be sure to watch for the single fantail LED in the video.
Package Contents:
1 x Fully assembled Nav/Strobe/Fantail Flasher Board
1 push button (Yellow or green whichever is available)
1 5mm Blre/Red common cathode LED.
10 3mm white LEDs.
2 3mm green LEDs.
2 3mm green LEDs.
1 1.8mm white LED for fantail with 120ohm resistor.
14 resistors.
Detailed 9 page Instruction Manual including information about LED's(Example setup for Parallel and Series), resistors, DC adapters, and voltage regulators sent by email..
Requires:
Solder.
Wire.
2mm heatshrink.
If the Item is out, you may email a request TO:
sales@starling-tech.com
